Do not let go of these two buttons until the Control is powered up. Software over-travels must be disabled by pressing and holding CAN and 'p' and then power up the Control.
After changing these Parameters the Control must be shut off. X HOME SET-UP X Axis Reference Position is 12.880 Inch. I'm not sure if I should change those to match the sheet. But then others are all zeros in the machine but the sheet has something different.
The sheet I have also has KWORDS on it and I was going to enter those but some of them were already changed from all zeros and matched my sheet. I went in and entered the 9000 option parameters and I can at least power up the machine fully now. I have a Hardinge build sheet that has about 10 option parameters but how do I know what to enter for all the rest? I found the Fanuc parameter manual but it just gives options for each parameter and doesn't actually say what to enter.Īpparently all the Hardinge techs are at IMTS and no one's called back yet. How do I reload them? I can't get the screen off the Ram Parity alarm page. Now when I start the machine I get a 910 RAM Parity (4N) alarm so I think my dumb mistake wiped all the parameters. I got a dead backup battery alarm on my Hardinge lathe and thinking it won't hurt anything since it's already dead, I pulled it out to take to the local battery place. Data can be transferred to and from the Power Mate via the FANUC I/O Link.This parameter. GE Fanuc Series 21/210 – Model B Parameter Manual.
0 kommentar(er)
